evo i novosti sa stranica iAqua
,
http://www.plantedtank.net/forums/20-diy/677265-iaqua-my-touch-interface-aquarium-controller-arduino-88.htmlčlan grupe MrMan proširio je opcije na:
-third dosing pump
-individual dosing amounts for each pump
-ATO control (float switch for tank/reservoir)
-12-bit LED PWM dimming (code set up for 6 channels, PCB for
-Lunar cycle
-Second DS18B20 temp sense
-Fan control using second temp sense (turns on/off at certain temperatures, planned for LED heatsink)
-On-board temp sense/fan control for inside controller housing
-Offset value for temp sensors to allow calibration
-Bargraph display for adjusting colors (only selectable to nearest 1% but uses full 12-bit range during transitions)
-Selectable colors for LED channels
-LED output vs time graph (no real use but it's nice when setting it up)
-Switched from tinyFAT libraries to sdfat and utft_sdraw which should allow for higher capacity SD cards
možda još fali pH